It appears to still be working OK so I've wrapped some tape round it for now. I would like to fix it properly at some point so I've been on a hunt for the connector.
It's a quite unique shape. With a little bit of research I'm fairly sure it is from the Micro Quadlok range, see the following from the manufacturer's site:
Housing: http://www.te.com/usa-en/product-1-967616-1.html
Contact pin: http://www.te.com/usa-en/product-1740336-1.html
Seal: http://www.te.com/usa-en/product-967056-1.html
They are available from RS Components with the associated components:
http://uk.rs-online.com/web/p/automotive-connectors/6801464/
http://uk.rs-online.com/web/p/automotive-connector-accessories/7180712/
http://uk.rs-online.com/web/p/automotive-connector-accessories/6802455/
Spelt in two different ways, so it needed multiple searches on the web site:
http://uk.rs-online.com/web/c/connectors/power-connectors/automotive-connector-accessories/?searchTerm=micro%20quadlok
http://uk.rs-online.com/web/c/connectors/power-connectors/automotive-connectors/?searchTerm=quadlock
I've also found a kit on e-bay which will be easier to buy but a bit more expensive:
http://www.ebay.co.uk/itm/Discovery-2-SLS-Air-Suspension-Ride-Height-Sensors-Harness-Connector-FREEPOST/172253397501
The clips that hold it on to the ride height sensor are a pain to get off so I have not yet managed to get the good one off. Once I have one in my hand to see close up, I'll practice releasing the latches before I have a go at the car again.
No comments:
Post a Comment